Specifications

7-19

Cisco MGX 8800/8900 Series Software Configuration Guide

Release 5.1, Part Number OL-6482-01, Rev. A0, January 25, 2005

Chapter 7 Managing Service Class Templates

Managing PXM1E Port SCTs

+--------------------------------------------------------------------+

Table 7-9 describes the SCT General Parameters shown in the example.

Table 7-9 SCT General Parameter Descriptions

Parameter Description

SERV-TYPE The service type (for example, CBR, VBR, ABR) to which the

parameters in this table apply (for example, COSB_NUM, CAC_TYPE,

UPC_ENB).

COSB_NUM Class of Service Buffer Number. The number that identifies one of the

sixteen CoS buffers. A CoS buffer is a buffer that services connections

with similar QoS requirements.

CAC_TYPE Connection Admission Control. Used by an ATM switch during setup

to determine if a connection requested QoS conforms to the guaranteed

QoS standards for ATM connections.

LCN_CAC = Logical Connection Number CAC

B_CAC = Basic - CAC

E_CAC = Enhanced - CAC

UPC_ENB Usage Parameter Control Enable. This parameter shows whether UPC

is enabled or disabled for the specified service type.

WFQ_ENB Weighted Fair Queuing Enable. This parameter shows whether WFQ is

enabled or disabled for the specified service type.

UPC_SELECT BKT1_BKT2 UPC selection for buckets 1 and 2. Specifies whether each bucket will

police for CLP (0+1) or CLP (0) in the dual leaky bucket policing

action. The following parameter values may be displayed:

• CLP01_CLP0 = Bucket 1: CLP (0+1), Bucket 2: CLP (0)

• CLP01_CLP01 = Bucket 1: CLP (0+1), Bucket 2: CLP (0+1)

• CLP01_DISC = Bucket 1: CLP (0+1), Bucket 2: Disabled. ? =

Bucket 1: CLP (0+1) with Maximum Frame Size (MFS)