Specifications

7-14
Cisco MGX 8800/8900 Series Software Configuration Guide
Release 5.1, Part Number OL-6482-01, Rev. A0, January 25, 2005
Chapter 7 Managing Service Class Templates
Managing PXM1E Port SCTs
mgx8830a.1.PXM.a > dspports
ifNum Line Admin Oper. Guaranteed Maximum Port SCT Id ifType VPI
State State Rate Rate (VNNI only)
----- ---- ----- ----- ---------- --------- ----------------- ------ ----------
1 1.1 Up Up 1412830 1412830 2 NNI 0
2 1.2 Up Up 1412830 1412830 2 NNI 0
3 2.1 Up Up 1412830 1412830 2 NNI 0
Selecting a Port SCT
A port SCT defines queue parameters that apply to egress queues on a port. You can use the same port
SCT for multiple ports. To select an SCT for a PXM1E port, enter the addport command as described
in “Adding ATM Ports in Chapter 3, “Provisioning PXM1E Communication Links.”
Note An SCT must be registered before you can select it for a card or port. The exception to this requirement
is the default SCT (SCT 0), which is permanently registered. For instructions on registering SCTs, see
Registering SCT Files,” which appears earlier in this chapter.
Changing a Port SCT
To change the SCT assigned to a port, enter the cnfport command as described in the “Managing Card
SCTs”.
Note An SCT must be registered before you can select it for a card or port. The exception to this requirement
is the default SCT (SCT 0), which is permanently registered. For instructions on registering SCTs, see
Registering SCT Files,” which appears earlier in this chapter.
Displaying Port SCT Settings
To view the port SCT settings, use the following procedure.
Step 1 Establish a CLI management session at any user access level.
Step 2 Enter the following command:
mgx8830a.1.PXM.a > dspportsct <abr|bw|gen|cosb|vcThr|cosThr> <ifNum>
Select one of the options to display one of the six SCT configuration reports, and replace <ifNum> with
the number of the port you want to view. Table 7-6 describes the reports for each of these options.
Note The option names are case sensitive. The switch does not recognize the vcthr option. You must
enter vcThr.