Specifications

7-13
Cisco MGX 8800/8900 Series Software Configuration Guide
Release 5.1, Part Number OL-6482-01, Rev. A0, January 25, 2005
Chapter 7 Managing Service Class Templates
Managing Card SCTs
Managing Card SCTs
Card SCTs are used only on service modules. For instructions on managing card SCTs on service
modules, refer to the service module documentation, which is listed in Table 1-1.
Managing PXM1E Port SCTs
The following sections describe how to manage PXM1E port SCTs using the following tasks:
• Displaying the SCT Assigned to a Port
• Selecting a Port SCT
• Changing a Port SCT
• Displaying Port SCT Settings
Note For instructions on managing port SCTs on service modules, refer to the service module documentation,
which is listed in Table 1-1.
Displaying the SCT Assigned to a Port
To display the SCT assigned to a PXM1E port, use the following procedure.
Step 1 Establish a configuration session at any user access level.
Step 2 Enter the following command:
mgx8830a.1.PXM.a > dspports
The dspports report displays a column labeled “Port SCT Id,” which identifies the SCT assigned to
each port.
checksum An SCT identification number between 0 and 65535 that matches the checksum embedded
in the SCT file. The checksum number for all new SCT files is advertised to the user
through the Release Notes for Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, and
Cisco MGX 8830 Switches, Release 5.1.00 and the Release Notes for the Cisco MGX 8880
Media Gateway, Release 5.0.02.
status Status of the SCT file on the switch. The status of the SCT would be marked as “failed”
if the file does not exist or does not match the major and minor versions.
description Identifies whether the file is provided by Cisco and displays the source filename.
Table 7-5 dspscts Command Display Components (continued)
Object Description