Specifications

7-8
Cisco MGX 8800/8900 Series Software Configuration Guide
Release 5.1, Part Number OL-6482-01, Rev. A0, January 25, 2005
Chapter 7 Managing Service Class Templates
Managing SCTs
Use the following procedure to manually register SCT files.
Step 1 Check the SCT temporary directory on the switch to see if the SCT file you want to register is available.
The directory path is C:SCT/TEMP. For information on viewing directories, see the “Browsing the File
System” section in Appendix A, “Downloading and Installing Software Upgrades.”
Step 2 If the SCT file you want to register is not on the switch, FTP the SCT file to the C:SCT/TEMP folder,
as described in the “Copying Software Files to the Switch” section in Appendix A, “Downloading and
Installing Software Upgrades.” For information on locating SCT files provided by Cisco, refer to the
following release note documents:
• Release Notes for Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, and Cisco MGX 8830
Switches, Release 5.1.00
• Release Notes for the Cisco MGX 8880 Media Gateway, Release 5.0.02
Step 3 Establish a CLI management session at any user access level.
Step 4 Obtain the checksum for the SCT file you are registering. You can look up the checksum in the release
note documents listed in Step 2.
Note The checksum is calculated based on the file contents. If two files share the same name and define
different configurations, the checksums will be different, and the registration process will detect the
conflict. When you use a checksum displayed in the Release Notes for your product, successful
registration verifies that the SCT is the same file that is distributed by Cisco. If registration with a Cisco
supplied checksum is unsuccessful, the SCT you are trying to register has been modified.
Step 5 Register the SCT file using the addsct command and the checksum displayed in the previous step. The
command format is:
D1.8.PXM.a > addsct <card type> <sct type> <sct id> <major ver> <checksum>
The required parameters identify the file name and the internal checksum and are defined in Table 7-3.
Table 7-3 addsct and cnfsct Command Parameters
Option Description
card type Identifies the type of card the SCT runs on. Enter one of the following:
• AXSM = axsm or 1
• AXSME = axsme or 2
• AXSM-16-155-XG = axsmxg or 5
• FRSM-12-T3E3 = frsm12 or 4
• MPSM-155-T3E3 = mpsm155 or 6
• MPSM-16-T1E1 = mpsm16
• PXM1E = pxm1e or 3
sct type Defines the SCT type as one of the following:
• Port SCT = 1
• Card SCT = 2
Note MGX 8850 (PXM1E) and MGX 8830 switches support only the PXM1E
port SCTs.