Specifications

3-78
Cisco MGX 8800/8900 Series Software Configuration Guide
Release 5.1, Part Number OL-6482-01, Rev. A0, January 25, 2005
Chapter 3 Provisioning PXM1E Communication Links
General PXM1E Configuration Procedures
Configuring the Master Side of SPVCs and SPVPs
To configure the master side of an SPVC, use the following procedure.
Step 1 Establish a configuration session using a user name with GROUP1 privileges or higher.
Tip During this procedure, you will have to enter the ATM address for the slave end of the
connection. If you establish this session from the same workstation you used to create the slave
connection, you can use the Copy and Paste commands to avoid data entry errors.
Step 2 Enter the following command to select the PXM1E card that hosts the master side of the SPVC:
PXM1E_SJ.8.PXM.a > cc <slotnumber>
Step 3 Define the master side of the SPVC by entering the addcon command:
PXM1E_SJ.8.PXM.a > addcon <ifNum> <vpi> <vci> <serviceType> <mastership>
[-casttype <casttype>] [-lpcr <cellrate>] [-rpcr <cellrate>] [-lscr <cellrate>]
[-rscr <cellrate>] [-lmbs <cells>] [-rmbs <cells>] [-cdvt <time>]
[-lcdv <time>] [-rcdv <time>] [-lctd <time>] [-rctd <time>]
[-cc <1|0>] [-stat <1|0>] [-frame <1|0>] [-mc <maxCost>] [-lputil <percentage>]
[-rputil <percentage>] [-slavepersflag <persistent|nonpersistent>]
[-routingprio <routingpriority>]
Note If you omit an optional parameter, the SPVC/SPVP uses the default value.
Table 3-17 lists and defines the parameters and options for this command. If you omit an option, the
SPVC uses the default value.
Tip The PCR, MBS, CDVT, CDV, MCR, and CTD options are optional. If you omit one of these
options when entering the addcon command, the connection uses the default value listed in
Table 3-17. To override the default values for any option, enter the option with a new value.
The following command example defines a port as the master side of an SPVC. Note the master id shown
in the command response.
PXM1E_SJ.8.PXM.a > addcon 12 135 135 1 1 -slave
4700918100000000001A533377000001073B0B00.125.125
master endpoint added successfully
master endpoint id : 4700918100000000001A533377000001073B0C00.135.135
Note To designate priority routing for this SPVC, you need to include the -routingprio
<routingpriority> option with the addcon command in this step.
Step 4 Verify the master-side SPVC addition by entering the following command:
PXM1E_SJ.8.PXM.a > dspcons