Specifications

3-71
Cisco MGX 8800/8900 Series Software Configuration Guide
Release 5.1, Part Number OL-6482-01, Rev. A0, January 25, 2005
Chapter 3 Provisioning PXM1E Communication Links
General PXM1E Configuration Procedures
vci addcon, cnfcon Enter the VCI for the slave side of the SPVC or SPVP.
SPVC Range: 32 to 65535.
SPVP Range: 0.
Note Cisco recommends setting the minimum VCI to 35 or
higher. Future products will use VCI 32 through 34
for other services.
serviceType addcon Replace <serviceType> with the number that corresponds to
the requested service type for this SPVC (this value must be
identical on master and slave sides). Possible service types
and their corresponding numbers are as follows:
• cbr1 = 1
• vbr1rt = 2
• vbr2rt = 3
• vbr3rt = 4
• vbr1nrt = 5
• vbr2nrt = 6
• vbr3nrt = 7
• ubr1 = 8
• ubr2 = 9
• abrstd = 10
• cbr2 = 11
• cbr3 = 12
mastership addcon Enter 2 or s if this port will serve as the slave side of the
connection. Enter 1 or m if the port serves as the master side
of the connection.
-casttype addcon The connection type is either point-to-point or
point-to-multipoint, as follows:
• Point-to-point = 0
• Point-to-multipoint = 1 (valid only for master
connection endpoints)
Default: point-to-point (0)
-slave addcon Keyword for the slave-end identifier, an item you enter at the
master end. This keyword is mandatory when you are adding
a master endpoint (mastership=m or 1).
Table 3-17 Parameters for the addcon and cnfcon Commands (continued)
Parameter Commands Description