Specifications

3-19
Cisco MGX 8800/8900 Series Software Configuration Guide
Release 5.1, Part Number OL-6482-01, Rev. A0, January 25, 2005
Chapter 3 Provisioning PXM1E Communication Links
Quickstart Provisioning Procedures
Cisco IGX Feeder to MGX 8830 or MGX 8850 (PXM1E) Configuration Quickstart
The quickstart procedure in this section provides a summary of the tasks required to configure a feeder
between a MGX 8850 (PXM1E) or MGX 8830 switch, and a Cisco IGX 8400 switch. This procedure is
provided as an overview and as a quick reference for those who have previously configured these types
of connections.
Step 8
uppnport <portid>
Related commands:
dsppnports
dsppnport <portid>
Bring up the configured port.
Step 9
If you are using CWM to manage your networks, the XLMI link
should be ready to use. Use CWM to add a connection from a
destination in the AutoRoute network to a destination in the PNNI
network.
Step 10
addcon <options> If you are not using CWM to manage your networks, add a
connection from the XLMI link endpoint on the PXM1E to a
destination on the PNNI network.
Note The PNNI connection you create must use the same VPI
and VCI as the connection defined in the AutoRoute
network.
See the “Provisioning and Managing SPVCs and SPVPs” section
later in this chapter.
Note Connections added with the CLI (addcon) command
cannot be managed by CWM. If you are using CWM,
create the connection with CWM. Afterwards, you can
modify the connection with CWM or the CLI.
Step 11
If you are not using CWM to manage your networks, add a
connection from the XLMI link endpoint on the BXM to a
destination on the AutoRoute network.
Note The AutoRoute connection you create must use the same
VPI and VCI as the connection defined in the PNNI
network.
For more information, refer to the Cisco BPX 8600 Series
Installation and Configuration guide.
Command Purpose