Specifications

2-2
Cisco MGX 8850 (PXM45) and MGX 8950 Software Configuration Guide
Release 3, Part Number 78-14788-01 Rev. C0, January 2004
Chapter 2 Configuring General Switch Features
Configuration Quickstart
Step 3
adduser <username>
<accessLevel>
Related commands:
cnfpasswd
cnfuser <options>
deluser <username>
Configure user access. This step is optional.
See the “Configuring User Access” section, which appears later
in this chapter.
Step 4
cnfname <node name> Configure the switch name.
See the “Setting and Viewing the Switch Name” section, which
appears later in this chapter.
Step 5
cnfdate <mm:dd:yyyy>
cnftmzn <timezone>
cnftmzngmt <timeoffsetGMT>
cnftime <hh:mm:ss>
Related commands:
dspdate
Configure the switch time.
See the “Viewing and Setting the Switch Date and Time” section,
which appears later in this chapter.
Step 6
addcontroller <options>
cnfpnni-node <options>
cnfspvcprfx <options>
Related commands:
dspcontrollers
dspspvcprfx
dsppnni-summary-addr
Configure basic PNNI node parameters which include the PNNI
controller, PNNI level, peer group ID, ATM address, node ID, and
SPVC prefix.
See the “Configuring PNNI Node Parameters” section, which
appears later in this chapter.
Step 7
addcontroller <options>
Related commands:
dspcontrollers
Add the MPLS controller.
See the “Configuring the MPLS Controller” section, which
appears later in this chapter.
Step 8
cnfclksrc <options>
or
cnfncdp
Configure any BITS clock ports the switch will use. This step is
optional.
See the “Configuring Clock Sources” section, which appears later
in this chapter.
Note For information on configuring AXSM line clock
sources, see the “Configuring AXSM Line Clock
Sources” section in Chapter 6, “Provisioning AXSM
Communication Links.”
Step 9
bootChange
ipifconfig <options>
Set the IP address or addresses for LAN access.
See the “Setting the LAN IP Addresses” section, which appears
later in this chapter.
Command Purpose