Specifications

Contents
v
Cisco MGX 8850 (PXM45) and MGX 8950 Software Configuration Guide
Release 3, Part Number 78-14788-01 Rev. C0, January 2004
Configuring PNNI Node Parameters 2-21
Adding the PNNI Controller 2-21
Setting the PNNI Level and Peer Group ID 2-22
Setting the PNNI Node Address 2-23
Setting the PNNI Node ID 2-24
Setting and Viewing the SPVC Prefix 2-26
Displaying PNNI Summary Addresses 2-27
Configuring the MPLS Controller 2-28
Configuring Clock Sources 2-28
Manually Configuring BITS Clock Sources 2-30
Enabling NCDP on a Node 2-31
Setting the LAN IP Addresses 2-33
Setting the Boot IP Address 2-33
Setting the LAN or Disk IP Address 2-35
Starting a CLI Session Through the LAN Port 2-38
Configuring for Network Management 2-39
Configuring the SNMP Trap Source IP Address 2-39
Configuring the SNMP Manager Destination IP Address 2-40
Configuring the Community String and General Switch Information 2-40
Verifying the Hardware Configuration 2-41
CHAPTER 3 Preparing AXSM Cards and Lines for Communication 3-1
Configuration Quickstart 3-1
Managing Firmware Version Levels for AXSM Cards 3-3
Locating Cards that Need the Firmware Version Set 3-3
Initializing AXSM Cards 3-4
Verifying Card Firmware Version Levels 3-5
Establishing Redundancy Between Two AXSM Cards 3-6
Selecting and Viewing Service Class Templates 3-7
Selecting a Card SCT 3-9
Selecting a Port SCT 3-11
Setting Up Lines 3-11
Bringing Up Lines 3-12
Configuring SONET Lines 3-15
Configuring T3 Lines 3-17
Configuring E3 Lines 3-18
Verifying Line Configuration 3-18