Specifications

9-11
Cisco MGX 8850 (PXM45) and MGX 8950 Software Configuration Guide
Release 3, Part Number 78-14788-01 Rev. C0, January 2004
Chapter 9 Viewing and Responding to Alarms
Displaying Alarm Reports in the CLI
Displaying Card Alarms
A card alarm report can display the alarm status of all the cards within the node or the alarm status of a
single card. To display card alarms, enter the following command:
pop20two.7.PXM.a > dspcdalms [slot]
Replace [slot] with the number of the card for which you want to display alarms. If you omit the slot
number, the switch displays the alarms for all cards in the node as shown in the following example:
M8850_LA.7.PXM.a > dspcdalms
Card Alarm Summary
Slot Critical Major Minor || Slot Critical Major Minor
---- -------- ------- ------- || ---- -------- ------- -------
1 1 0 0 || 17 0 0 0
2 0 0 0 || 18 0 0 0
3 0 0 0 || 19 0 0 0
4 0 0 0 || 20 0 0 0
5 0 0 0 || 21 0 0 0
6 0 0 0 || 22 0 0 0
7 0 0 0 || 23 0 0 0
8 0 0 0 || 24 0 0 0
9 0 0 0 || 25 0 0 0
10 0 0 0 || 26 0 0 0
11 0 0 0 || 27 0 0 0
12 0 0 0 || 28 0 0 0
13 0 0 0 || 29 0 0 0
14 0 0 0 || 30 0 0 0
15 0 1 0 || 31 0 1 0
16 0 1 0 || 32 0 1 0
Use dspcdalms <slot> to see more detail.
The next example shows a card alarm report for an AXSM card in slot 1:
M8850_LA.7.PXM.a > dspcdalms 1
Card Alarm Summary
Alarm Type Critical Major Minor
---------- -------- ------- -------
Hardware Alarm 0 0 0
Card State Alarm 0 0 0
Disk Alarm 0 0 0
SRM Alarm 0 0 0
Line Alarm 1 0 0
Port Alarm 0 0 0
Feeder Alarm 0 0 0
Channel Alarm 0 0 0
Table 9-5 lists commands that you can use to display additional information about alarms that appear in
the dspcdalms report.