Specifications

9-6

Cisco MGX 8850 (PXM45) and MGX 8950 Software Configuration Guide

Release 3, Part Number 78-14788-01 Rev. C0, January 2004

Chapter 9 Viewing and Responding to Alarms

Displaying Alarm Reports in the CLI

You can use a CLI session to view the status of node alarms. Alarms are reported in the following

categories:

• Node alarms

• Clock alarms

• Switching alarms

• Environment alarms

• Card alarms

This section describes how to display the different types of alarm reports.

Note The procedures in the following sections can be completed by users at all access levels.

Displaying Node Alarms

A node alarm report displays a summary report of all alarms on the node. To display node alarms, enter

the following command:

pop20two.7.PXM.a > dspndalms

Table 9-3 LED Indicators for RPM-PR Card

LED Color Description

CPU OK Green RPM-PR has successfully loaded the boot or runtime software.

Yellow ROMMON passed the Power On Self-Test (POST).

Red POST failure.

Off No power or ROMMON cannot execute POST.

CB TX On Transmitting cells on cellbus.

Off Not transmitting cells on cellbus.

CB RX On Receiving cells from cellbus. This light stays on solid when downloading

software.

Off Not receiving cells from cellbus.

LM1 OK On Port adapter installed and enabled in bay 1.

Off No port adapter installed in bay 1.

LM2 OK On Port adapter installed and enabled in bay 2.

Off No port adapter installed in bay 2.