Specifications

9-5
Cisco MGX 8850 (PXM45) and MGX 8950 Software Configuration Guide
Release 3, Part Number 78-14788-01 Rev. C0, January 2004
Chapter 9 Viewing and Responding to Alarms
Viewing and Responding to Alarms Using Physical Switch Controls
RPM-PR Card Controls
Figure 9-3 shows the LEDs available on the front of the RPM-PR card. Table 9-3 describes these LEDs.
Figure 9-3 RPM-PR Card Controls
Table 9-2 LED Indicators for AXSM Card
LED Color Description
Active Green Card is active.
Standby Yellow Card is in standby mode.
Fail Red Failure detected on card.
PORT Green Line is active; there are no alarms.
Red Line is active, but a local alarm has been detected.
Yellow Line is active; a remote alarm has been detected.
CPU OK
CB TX
CB RX
LMI OK
LM2 OK
RPM
AUX
CONSOLE
53282
CPU OK
CBTX
CBRX
LM1 OK
LM2 OK
Auxiliary serial port, supports
hardware flow control
Console port serial connector
Green = Card has successfully loaded boot or runtime image.
Yellow = ROMMON passed the Power On Self Test (POST).
Red = POST failure.
Off = No power or ROMMON cannot execute POST.
On = Transmitting cells on cellbus
Off = No transmission on cellbus
On = Receiving cells on cellbus
Off = No reception on cellbus
On = Port adapter installed and enabled in bay 1
Off = No port adapter in bay 1
On = Port adapter installed and enabled in bay 2
Off = No port adapter in bay 2