Specifications

7-95
Cisco MGX 8850 (PXM45) and MGX 8950 Software Configuration Guide
Release 3, Part Number 78-14788-01 Rev. C0, January 2004
Chapter 7 Switch Operating Procedures
Diagnostics Support MGX 8850 and MGX 8950 Switches
Warning Do not remove the active PXM while the offline diagnostic is running on the redundant PXM. If you
remove it, the redundant PXM reboots but will not be able to become active unless its hard disk
drive was previously synchronized to the hard disk on the previously active PXM.
Example 7-1 Configuring online diagnostics only
In the following example, the user enables online diagnostics only for the AXSME in slot 7.
8850_NY.7.PXM> cnfdiag 7 enable disable
Example 7-2 Configuring offline diagnostics only
In the following example, the user enables online diagnostics for the AXSME in slot 7. A medium online
diagnostics coverage test is scheduled to run every Wednesday at 11:30 (11:30 AM).
8850_NY.7.PXM> cnfdiag 7 disable enable medium 11:30 -W
Table 7-47 cnfdiag command Parameters
Parameter Description
slot Enter the slot of the card for which to configure
the diagnostics. For the AXSME, the slot number
will be 7 or 8.
onEnb Enter enable to enable online diagnostic on the
card. Enter disable to disable offline diagnostics.
offEnb Enter enable to enable offline diagnostics. Enter
disable to ensure that offline diagnostics are
disabled while online diagnostics are running.
offCover Set the offline diagnostics coverage time to light,
medium, or full.
light = 5 minutes or less
medium = 30 minutes or less
full = any number of minutes-no limit
Note You do not need to set this parameter if
you are not enabling offline diagnostics.
offStart Set the time for the offline diagnostics to begin
us i ng 24 h o u r ti m e . Th e f orma t i s : hh : m m . For
example: 03:45 or 22:30
Note You do not need to set this parameter if
you are not enabling offline diagnostics.
offDow Sets the day of the week for the offline diagnostics
to run. The format is SMTWTFS.
Note You do not need to set this parameter if
you are not enabling offline diagnostics.