Specifications

7-66
Cisco MGX 8850 (PXM45) and MGX 8950 Software Configuration Guide
Release 3, Part Number 78-14788-01 Rev. C0, January 2004
Chapter 7 Switch Operating Procedures
Managing Partitions
Note The current software release does not support dynamic changes to partitions. To begin using
changes to a resource partition, you need to delete the controller and then add the controller as
described in the rest of this procedure.
Step 5 Display the available controllers with the dspcontrollers command, and write down the controller
settings for the controller you are about to delete. For example:
pop20two.7.PXM.a > dspcontrollers
pop20two System Rev: 02.01 Feb. 08, 2001 19:10:33 PST
MGX8850 Node Alarm: NONE
Number of Controllers: 2
Controller Name: PNNI Controller
Controller Id: 2
Controller Location: Internal
Controller Type: PNNI
Controller Logical Slot: 7
Controller Bay Number: 0
Controller Line Number: 0
Controller VPI: 0
Controller VCI: 0
Controller In Alarm: NO
Controller Error:
Controller Name: MPLS Controller
Controller Id: 3
Controller Location: Internal
Controller Type: LSC
Controller Logical Slot: 7
Controller Bay Number: 0
Controller Line Number: 0
Type <CR> to continue, Q<CR> to stop:
pop20two System Rev: 02.01 Feb. 08, 2001 19:10:33 PST
MGX8850 Node Alarm: NONE
Controller VPI: 0
Controller VCI: 0
Controller In Alarm: NO
Controller Error:
Step 6 Enter the delcontroller command to delete the controller that corresponds to the resource partition you
modified. For example:
pop20two.7.PXM.a > delcontroller 3
All Ports and Connections
on this controller will be deleted.
delcontroller: Do you want to proceed (Yes/No)? y
Step 7 To register the resource partition changes, add the deleted controller with the addcontroller command.
For example:
pop20two.7.PXM.a > addcontroller 3 i 3 7 "MPLS Controller"
Step 8 To verify that the controller was added correctly, enter the dspcontrollers command.