Specifications

7-62
Cisco MGX 8850 (PXM45) and MGX 8950 Software Configuration Guide
Release 3, Part Number 78-14788-01 Rev. C0, January 2004
Chapter 7 Switch Operating Procedures
Managing Partitions
Step 3 To display the port configuration, enter the following command:
mgx8850a.10.AXSM.a > dspport <ifNum>
Replace ifNum with the number assigned to the port during configuration. The following example shows
the report for this command:
mgx8850a.10.AXSM.a > dspport 2
Interface Number : 2
Line Number : 2.1
Admin State : Up Operational State : Down
Guaranteed bandwidth(cells/sec): 100000 Number of partitions: 1
Maximum bandwidth(cells/sec) : 100000 Number of SPVC : 0
ifType : NNI Number of SVC : 0
SCT Id : 6
VPI number(VNNI only) : 0
Managing Partitions
The following sections describe how to display, change, and delete a resource partition.
Displaying a Resource Partition Configuration
To display a list of resource partitions or a resource partition configuration, use the following procedure.
Step 1 Establish a CLI management session at any user access level.
Step 2 To display a list showing the resource partitions on this card, enter the following command:
mgx8850a.10.AXSM.a > dspparts
The switch displays a report similar to the following:
mgx8850a.10.AXSM.a > dspparts
if part Ctlr egr egr ingr ingr min max min max min max
Num ID ID GuarBw MaxBw GuarBw MaxBw vpi vpi vci vci conn conn
(.0001%)(.0001%)(.0001%)(.0001%)
-----------------------------------------------------------------------------
1 1 2 1000000 1000000 1000000 1000000 0 4095 52 65535 10000 10000
2 1 2 1000000 1000000 1000000 1000000 0 255 52 65535 5000 5000
Step 3 To display the configuration of a resource partition, note the interface and partition numbers and enter
the following command:
mgx8850a.10.AXSM.a > dsppart <ifNum> <partId>