Specifications

7-61
Cisco MGX 8850 (PXM45) and MGX 8950 Software Configuration Guide
Release 3, Part Number 78-14788-01 Rev. C0, January 2004
Chapter 7 Switch Operating Procedures
Viewing an ATM Port Configuration
Step 3 Enter the dspscts command to ensure that the proper SCT was deleted from your network.
Viewing an ATM Port Configuration
To view the configuration of an ATM line or trunk port, use the following procedure.
Step 1 Establish a CLI management session at any user access level.
Step 2 To display a list of the ports already configured on the AXSM card, enter the following command:
mgx8850a.10.AXSM.a > dspports
This command displays all configured ports on the AXSM card. Port numbers are listed in the ifNum
(interface number) column. The interfaces listed include UNI and NNI ports. Note the number of the port
for which you want to view the configuration.
Table 7-32 cnfsct Command Parameters
Option Description
card type Identifies the type of card the SCT runs on. The possible card
types are as follows:
1: AXSM
2: AXSME
3: PXM (for PXM1E only)
4: HSFR.
type Determines whether the SCT is a port SCT or a card SCT.
SCT d Number between 1 and 65335 which identifies an SCT.
major ver Major version number of a file. This number changes when a new
parameter is added to a MIB. Only Cisco can generate a new
major version of a file.
checksum SCT identification number that comes from Cisco and is
published in the release notes. The checksum number an be from
1 to 132 characters, but cannot included space characters.
description Describes the SCT file.