Specifications

7-47
Cisco MGX 8850 (PXM45) and MGX 8950 Software Configuration Guide
Release 3, Part Number 78-14788-01 Rev. C0, January 2004
Chapter 7 Switch Operating Procedures
Managing Service Class Templates
The dspports report displays a column labeled “Port SCT Id,” which identifies the SCT assigned to each
port, as shown in the following example:
pop20two.1.AXSM.a > dspports
ifNum Line Admin Oper. Guaranteed Maximum Port SCT Id ifType VPI
State State Rate Rate (VNNI only)
----- ---- ----- ----- ---------- --------- ----------------- ------ ----------
1 1.1 Up Up 1412830 1412830 2 NNI 0
2 1.2 Up Up 1412830 1412830 2 NNI 0
3 2.1 Up Up 1412830 1412830 2 NNI 0
4 2.2 Up Up 1412830 1412830 2 UNI 0
Displaying the SCT Assigned to a Card
To display the SCT assigned to a card, use the following procedure.
Step 1 Establish a configuration session at any user access level.
Step 2 Enter the following command:
pop20two.9.AXSM.a > dspcd
The dspcd report displays a row labeled “Card SCT Id,” which identifies the SCT assigned to the card.
pop20two.1.AXSM.a > dspcd
Front Card Upper Card Lower Card
---------- ---------- ------------
Card Type: AXSM-4-622 SMFIR-2-622 SMFIR-2-622
State: Active Present Present
Serial Number: SAK03500088 SBK0406002V SAK0346003F
Boot FW Rev: 2.0(252)A1 --- ---
SW Rev: 2.0(252)A1 --- ---
800-level Rev: M6 14 13
Orderable Part#: 800-5774-5 800-5383-1 800-5383-1
PCA Part#: 73-4504-2 73-4125-1 73-4125-1
Reset Reason:On Power up
Card SCT Id: 2
Type <CR> to continue, Q<CR> to stop:
Displaying Port SCT Settings
To view the port SCT settings, use the following procedure.
Step 1 Establish a CLI management session at any user access level.
Step 2 Enter the following command:
pop20two.9.AXSM.a > dspportsct <bw|gen|cosb|vcThr|cosThr> <ifNum>