Specifications

7-42
Cisco MGX 8850 (PXM45) and MGX 8950 Software Configuration Guide
Release 3, Part Number 78-14788-01 Rev. C0, January 2004
Chapter 7 Switch Operating Procedures
Managing Feeder Connections
Managing Feeder Connections
The procedure for defining feeder connections is described in Chapter 6, “Provisioning AXSM
Communication Links.” Table 7-21 lists commands that you can use to manage feeder connections.
Displaying SVCs
To display active SVCs, use the following procedure.
Step 1 Establish a CLI management session at any user access level.
Step 2 Enter the dsppncons command.
popeye2.7.PXM.a > dsppncons
The following is an example report for the dsppncons command.
popeye2.7.PXM.a > dsppncons
Port VPI VCI CallRef X-Port VPI VCI CallRef Type OAM-Type
9:1.1:1 0 32 1 9:1.2:2 0 36 5 PTP No
Calling-Addr:47.666666666666666666666666.666666666666.00
Called-Addr: 47.111111111111111111111111.111111111111.64
9:1.2:2 0 36 5 9:1.1:1 0 32 1 PTP No
Calling-Addr:47.666666666666666666666666.666666666666.00
Called-Addr: 47.111111111111111111111111.111111111111.64
Managing Controllers
Cisco MGX 8850 and Cisco MGX 8950 Release 2 switches support one PNNI controller and up to two
Label Switch Controllers. The controller identifies a network control protocol to the Virtual Switch
Interface (VSI) that runs on the node.
Table 7-21 Feeder Management Commands
Command Description
dspfdrs Display the feeders configured on an AXSM card.
dspfdr <ifnum> Display the feeder configuration for a specific interface. Replace <ifnum> with
the interface number.
dspfdrstat <ifnum> Display statistics on a feeder interface. Replace <ifnum> with the interface
number.
clrfdrstat <ifnum> Clear statistics counters for a feeder interface. Replace <ifnum> with the
interface number.
delfdr <ifnum> Remove the feeder configuration from an interface. Replace <ifnum> with the
interface number.