Specifications

7-24
Cisco MGX 8850 (PXM45) and MGX 8950 Software Configuration Guide
Release 3, Part Number 78-14788-01 Rev. C0, January 2004
Chapter 7 Switch Operating Procedures
Managing Redundant APS Lines
Switching APS Lines
To switch between two APS lines, enter the switchapsln command as described in the following
procedure.
Step 1 Establish a configuration session using a user name with GROUP1_GP privileges or higher.
Step 2 Enter the switchapsln command as follows:
pop20one.9.AXSM.a > switchapsln <bay> <line> <switchOption> <serviceSwitch>
Select the working line to switch by replacing <bay> with the bay number of the working line, and
replacing <line> with the line number for the working line.
Table 7-7 describes the other options you can use with this command.
-wtr The number of minutes to wait before attempting to switch back to the working line.
Replace <Wait To Rest ore> with a number in the range of 1 to 12 (minutes).
Note This option is applicable only when the -rv option is set to 2, enabling revertive
operation.
-dr The direction option, which specifies the communication paths to be switched when a
failure occurs. The options are unidirectional or bidirectional. When the unidirectional
option is selected, only the affected path, either transmit or receive, is switched. When the
bidirectional option is selected, both paths are switched.
To set this option, replace the <direction> variable with 1 for unidirectional operation or 2
for bidirectional operation.
-rv The revertive option, which defines how the switch should operate when a failed line
recovers. The options are revertive and nonrevertive. When the -rv option is configured for
revertive operation and the working line recovers, the switch will switch back to the working
line after the period specified by the -wtr option. If the line is configured for nonrevertive
operation, a failure on the working line will cause the switch to use the protect line until a
manual switchover is initiated as described in the “Switching APS Lines” section.
To set this option, replace the <revertive> variable with 1 for non-revertive operation or 2
for revertive operation.
Table 7-6 Options for cnfapsln Command (continued)
Option Description