Specifications

7-12
Cisco MGX 8850 (PXM45) and MGX 8950 Software Configuration Guide
Release 3, Part Number 78-14788-01 Rev. C0, January 2004
Chapter 7 Switch Operating Procedures
Displaying Software Revisions in Use
Table 7-3 shows some example filenames and the correct version numbers to use with the revision
management commands.
Displaying Software Revisions in Use
The following sections describe:
• Displaying Software Revisions for All Cards
• Displaying Software Revisions for a Single Card
Displaying Software Revisions for All Cards
To display the boot and runtime software version in use on every card in the switch, enter the dsprevs
command as shown in the following example:
pop20one.7.PXM.a > dsprevs
pop20one System Rev: 02.00 Jan. 24, 2001 18:32:57 PST
MGX8850 Node Alarm: NONE
Physical Logical Inserted Cur Sw Boot FW
Slot Slot Card Revision Revision
-------- ------- -------- -------- --------
01 01 AXSM_4OC12 2.0(12) 2.0(12)
02 02 AXSM_4OC12 2.0(12) 2.0(12)
03 03 --- --- ---
04 04 --- --- ---
05 05 --- --- ---
06 06 --- --- ---
07 07 PXM45 2.0(12) 2.0(12)
08 07 PXM45 2.0(12) 2.0(12)
09 09 --- --- ---
10 10 --- --- ---
11 11 --- --- ---
12 12 --- --- ---
13 13 --- --- ---
14 14 --- --- ---
15 15 --- --- ---
16 16 --- --- ---
Type <CR> to continue, Q<CR> to stop:
Table 7-3 Determining Firmware Version Numbers from Filenames
Filename
Version Number for Revision
Management Commands
pxm45_002.000.000.000_bt.fw 2.0(0)
pxm45_002.000.001.000_bt.fw 2.0(1)
axsm_002.000.001.001.fw 2.0(1.1)
pxm45_002.000.001-D_mgx.fw 2.0(1)D
pxm45_002.000.014-A1_bt.fw 2.0(14)A1
axsm_002.000.016-D.fw 2.0(16)D