Specifications

7-8
Cisco MGX 8850 (PXM45) and MGX 8950 Software Configuration Guide
Release 3, Part Number 78-14788-01 Rev. C0, January 2004
Chapter 7 Switch Operating Procedures
Managing ILMI
Replace portid using the format slot:bay.line:ifNum. Table 7-1 describes these parameters. The
following example shows the format of the dsppnilmi command report.
pop20one.7.PXM.a > dsppnilmi 10:1.1:1
Port: 10:1.1:1 Port Type: PNNI Side: network
Autoconfig: disable UCSM: disable
Secure Link Protocol: enable
Change of Attachment Point Procedures: enable
Modification of Local Attributes Standard Procedure: enable
Addressreg: Permit All
VPI: 0 VCI: 16
Max Prefix: 16 Total Prefix: 0
Max Address: 64 Total Address: 0
Resync State: 0 Node Prefix: yes
Peer Port Id: 16848897 System_Id : 0.80.84.171.226.192
Peer Addressreg: enable
Peer Ip Address : 0.0.0.0
Peer Interface Name : atmVirtual.01.1.1.01
ILMI Link State : UpAndNormal
ILMI Version : ilmi40
INFO: No Prefix registered
Displaying and Clearing ILMI Management Statistics
The following procedure describes some commands you can use to view ILMI management statistics.
Step 1 To display ILMI management statistics for a port, enter the dspilmicnt command as follows:
pop20one.10.AXSM.a > dspilmicnt <ifnum> <partitionId>
Replace ifnum with the interface number of the port, and replace partitionID with the partition number
assigned to the port. You can view both of these numbers in the dspilmis command report. The following
is an example report for the dspilmicnt command.
pop20one.10.AXSM.a > dspilmicnt 1 1
If Number : 1
Partition Id : 1
SNMP Pdu Received : 36914
GetRequest Received : 18467
GetNext Request Received : 0
SetRequest Received : 0
Trap Received : 1
GetResponse Received : 18446
GetResponse Transmitted : 18467
GetRequest Transmitted : 18446
Trap Transmitted : 4
Unknown Type Received : 0
ASN1 Pdu Parse Error : 0
No Such Name Error : 0
Pdu Too Big Error : 0
Note Partition ID 1 is reserved for PNNI.