Specifications

7-7
Cisco MGX 8850 (PXM45) and MGX 8950 Software Configuration Guide
Release 3, Part Number 78-14788-01 Rev. C0, January 2004
Chapter 7 Switch Operating Procedures
Managing ILMI
Replace ifnum with the interface number of the port, and replace partitionID with the partition number
assigned to the port. You can view both of these numbers in the dspilmis command report. The following
is an example report for the dspilmi command. Ta bl e 7-2 describes each of the columns that appear in
the command report.
pop20one.10.AXSM.a > dspilmi 1 1
Sig. rsrc Ilmi Sig Sig Ilmi S:Keepalive T:conPoll K:conPoll
Port Part State Vpi Vci Trap Interval Interval InactiveFactor
---- ---- ---- ---- ---- --- ------------ ---------- ----------
1 1 On 0 16 On 1 5 4
Step 4 To display the operational state of ILMI on all ports, enter the dsppnports command at the PXM45
prompt as shown in the following example:
pop20one.7.PXM.a > dsppnports
Summary of total connections
(p2p=point to point,p2mp=point to multipoint,SpvcD=DAX spvc,SpvcR=Routed spvc)
Type #Svcc: #Svpc: #SpvcD: #SpvpD: #SpvcR: #SpvpR: #Total:
p2p: 0 0 0 0 0 0 0
p2mp: 0 0 0 0 0 0 0
Total=0
Summary of total configured SPVC endpoints
Type #SpvcCfg: #SpvpCfg:
p2p: 0 0
p2mp: 0 0
Per-port status summary
PortId IF status Admin status ILMI state #Conns
7.35 up up Undefined 0
7.36 up up Undefined 0
7.37 up up Undefined 0
7.38 up up Undefined 0
Type <CR> to continue, Q<CR> to stop:
10:1.1:1 up up UpAndNormal 0
The ILMI operational state is displayed as one of the following: Disable, EnableNotUp, or
UpAndNormal. When ILMI is disabled on the port, the operational status is Disable. When ILMI is
enabled on the local port but cannot communicate with ILMI on the remote port, the status is
EnableNotUp (this happens when ILMI is disabled on the remote end). When ILMI is enabled and
communicating with ILMI on the remote port, the ILMI state is UpAndNormal.
Step 5 To display ILMI configuration data for a specific port, use the dsppnilmi command at the PXM45
prompt as follows:
pop20one.7.PXM.a > dsppnilmi <portid>