Specifications

6-23
Cisco MGX 8850 (PXM45) and MGX 8950 Software Configuration Guide
Release 3, Part Number 78-14788-01 Rev. C0, January 2004
Chapter 6 Managing PNNI Nodes and PNNI Routing
Displaying Node Configuration Information
Displaying Routing Policy Parameters
Enter the dsppnni-timer command to display the routing policy parameters:
Geneva.7.PXM.a > dsppnni-timer
The following example shows the report for this command:
Geneva.7.PXM.a > dsppnni-timer
node index: 1
Hello holddown(100ms)... 10 PTSE holddown(100ms)... 10
Hello int(sec).......... 15 PTSE refresh int(sec).. 1800
Hello inactivity factor. 5 PTSE lifetime factor... 200
Retransmit int(sec)..... 5
AvCR proportional PM.... 50 CDV PM multiplier...... 25
AvCR minimum threshold.. 3 CTD PM multiplier...... 50
Peer delayed ack int(100ms)................... 10
Logical horizontal link inactivity time(sec).. 120
Displaying the SVCC RCC Table
Enter the dsppnni-svcc-rcc command to display the PNNI SVCC RCC Table.
Geneva.7.PXM.a > dsppnni-svcc-rcc [node-index] [svc-index]
If you specify:
• Both node-index and svc-index, command displays information about an SVCC-based RCC.
• Only node-index, command displays all SVC-based RCCs attached to the svc-index node.
• Nothing, command displays all SVC-based RCCs attached to all PNNI nodes on this WAN.
Geneva.7.PXM.a > dsppnni-svcc-rcc
Objects Displayed (for each RCC):
‘‘
node index - 32-bit number.
svc index - 32-bit number.
hello state - ascii string.
Down
Attempt
1wayInside
2wayInside
1wayOutside
callingIntegrityTime The amount of time (in seconds) this node will wait for an SVCC,
which it has initiated establishment of as the calling party, to become
fully established before giving up and tearing it down. The range is
from 5 to 300
calledIntegrityTime The amount of time (in seconds) this node will wait for an SVCC,
which it has decided to accept as the called party, to become fully
established before giving up and tearing it down. The range is from 10
to 300.
Table 6-11 Objects Displayed for the dsppnni-svcc-rcc-timer Command
Parameter Description