Specifications

6-12
Cisco MGX 8850 (PXM45) and MGX 8950 Software Configuration Guide
Release 3, Part Number 78-14788-01 Rev. C0, January 2004
Chapter 6 Managing PNNI Nodes and PNNI Routing
Managing PNNI Route and Link Selection
Associating an SPVC or an SPVP with a Preferred Route
Use the following procedure to associate an SPVC or SPVP with a preferred route.
Step 1 Create the preferred route by the addpref command, as shown in the previous section.
Step 2 If not already done, create the SPVC/SPVP by using the addcon command, as described in
Step 3 Enter the cnfconpref <options> command to associate an SPVC or SPVP with a preferred route.
Table 6-6 describes the cnfconpref command parameters.
Table 6-6 Parameters for cnfconpref Command
Parameter Description
portid Identifies a PNNI physical port, in the format slot:subslot.port:subport
vpi VPI of the connection.
Range: 0-255 on a UNI, 0-4095 on an NNI
Default: none
vci VCI of the connection. If the VCI is 0, the connection is an SPVP.
Range: 1-65535
Default: none
rteID The route identifier.
Range: 1-5000
Default: none
-assoc The -assoc option either associates (-assoc set) or disassociates (-assoc
clr) the specified route to the specified connection. If you type -assoc set
to associate a route, the command entry must include the route ID. If you
disassociate the route by typing -assoc clr, the route ID is unnecessary.
Because set is the default, if you type a route ID but do not include -assoc
set, the protocol interprets the command as an attempt to associate the
specified route to the specified connection.
Possible entries: set or clr (for clear)
Default: set