Specifications

6-5
Cisco MGX 8850 (PXM45) and MGX 8950 Software Configuration Guide
Release 3, Part Number 78-14788-01 Rev. C0, January 2004
Chapter 6 Managing PNNI Nodes and PNNI Routing
Managing PNNI Nodes
To view the status of the -transitRestricted option, enter the dsppnni-node command as shown in the
following example:
8850_LA.7.PXM.a > dsppnni-node
node index: 1 node name: 8850_LA
Level............... 56 Lowest.............. true
Restricted transit.. on Complex node........ off
Branching restricted on
Admin status........ up Operational status.. up
Non-transit for PGL election.. off
Node id...............56:160:47.00918100000100001a531c2a.00001a531c2a.01
ATM address...........47.00918100000100001a531c2a.00001a531c2a.01
Peer group id.........56:47.00.9181.0000.0100.0000.0000.00
Enabling and Disabling Point-to-Multipoint Routes
The branching restricted option allows you to allow or block point-to-multipoint calls. The default
setting for this option enables point-to-multipoint calls.
To enable or disable point-to-multipoint routes through a node, enter the cnfpnni-node command as
follows:
8850_LA.7.PXM.a > cnfpnni-node <node-index > -branchingRestricted on|off
Replace node-index with the index that identifies the logical node you are modifying, and enter either
on or off for the -branchingRestricted parameter. When this parameter is set to on, the node does not
accept point-to-multipoint calls. When the -branchingRestricted parameter is set to off, the node accepts
point-to-multipoint calls.
To view the status of the -branchingRestricted option, enter the dsppnni-node command as shown in the
following example:
8850_LA.7.PXM.a > dsppnni-node
node index: 1 node name: 8850_LA
Level............... 56 Lowest.............. true
Restricted transit.. off Complex node........ off
Branching restricted on
Admin status........ up Operational status.. up
Non-transit for PGL election.. off
Node id...............56:160:47.00918100000100001a531c2a.00001a531c2a.01
ATM address...........47.00918100000100001a531c2a.00001a531c2a.01
Peer group id.........56:47.00.9181.0000.0100.0000.0000.00
Adding an ATM Summary Address Prefix
Enter the addpnni-summary-addr command to add an ATM summary address prefix for a PNNI logical
node on the switch.
Geneva.7.PXM.a > addpnni-summary-addr <node-index> <address-prefix> <prefix-length> [-type]
[-suppress] [-state]