Specifications

4-8
Cisco MGX 8850 (PXM45) and MGX 8950 Software Configuration Guide
Release 3, Part Number 78-14788-01 Rev. C0, January 2004
Chapter 4 Preparing FRSM12 Cards and Lines for Communication
Selecting and Viewing Service Class Templates
Note When an FRSM12 card is powered up for the first time, the default card SCT file is used. You
must run this command in order to use another SCT file. The default SCT file is 0.
Replace sctID with the number of the SCT that you want to assign to the card. For PNNI
communications, use SCT ID 2 or 4 for policing applications and use SCT ID 3 or 5 for non-policing
applications. If MPLS will be used on any card link, use SCT ID 4 for policing applications and use SCT
ID 5 for non-policing applications.
Note For most applications, Cisco Systems recommends using non-policing card SCTs.
Step 3 To display the SCT assigned to a card, enter the following command:
pop20two.1.FRSM12.a > dspcd
The display card report displays a row labeled “Card SCT Id,” which identifies the SCT assigned to the
card.
Selecting a Port SCT
A port SCT defines ATM parameters that apply to communications through a single port. You can use
the same port SCT for multiple ports. To select an SCT for a port, enter the addport command as
described in Frame Relay Services for MGX Release 3.0 Switches.