Specifications

4-3
Cisco MGX 8850 (PXM45) and MGX 8950 Software Configuration Guide
Release 3, Part Number 78-14788-01 Rev. C0, January 2004
Chapter 4 Preparing FRSM12 Cards and Lines for Communication
Managing Firmware Version Levels for FRSM12 Cards
The following example shows the display for this command. The card state for the card in slot 4 is listed
as Failed/Active. This is how a card appears when the runtime firmware version has not been selected.
hsfrnd6.8.PXM.a > dspcds
hsfrnd6 System Rev: 03.00 Feb. 15, 2002 06:10:03 GMT
Chassis Serial No: SCA044304MV Chassis Rev: E0 GMT Offset: 0
Node Alarm: MAJOR
Card Front/Back Card Alarm Redundant Redundancy
Slot Card State Type Status Slot Type
--- ---------- -------- -------- ------- -----
01 Empty --- --- --- ---
02 Empty --- --- --- ---
03 Empty --- --- --- ---
04 Failed/Active FRSM12_12T3E3 MAJOR NA NO REDUNDANCY
05 Empty --- --- --- ---
06 Empty --- --- --- ---
07 Empty Resvd/Empty --- NONE 08 PRIMARY SLOT
08 Active/Active PXM45 NONE 07 SECONDARY SLOT
09 Empty --- --- --- ---
10 Empty --- --- --- ---
11 Active/Active FRSM12_12T3E3 NONE NA NO REDUNDANCY
12 Empty --- --- --- ---
13 Empty Resvd/Empty --- MAJOR NA NO REDUNDANCY
14 Empty --- --- --- ---
17 Empty --- --- --- ---
Type <CR> to continue, Q<CR> to stop:
Note the slot number, card type, and redundancy type for each card that needs to have the firmware
version set. You will need this information to activate these cards as described in the next section,
“Initializing FRSM12 Cards.”
Note If any FRSM12 card displays the Active/Active card state, you do not have to set the runtime
firmware version for that card.