Specifications

3-22
Cisco MGX 8850 (PXM45) and MGX 8950 Software Configuration Guide
Release 3, Part Number 78-14788-01 Rev. C0, January 2004
Chapter 3 Preparing AXSM Cards and Lines for Communication
Establishing Redundancy Between Two Lines with APS
Step 6 Enter the dspapsbkplane command on both the standby and active cards to verify that the APS
connector is installed properly.
Note This command can show different values for each of the two cards, which indicates the APS
connector is seated properly on one card, but not on the other.
Step 7 To display the a list of all the APS lines on an AXSM card, enter the dspapslns command.
For information on managing redundant APS lines, see the “Managing Redundant APS Lines” section
in Chapter 7, “Switch Operating Procedures.”