Specifications
3-10
Cisco MGX 8850 (PXM45) and MGX 8950 Software Configuration Guide
Release 3, Part Number 78-14788-01 Rev. C0, January 2004
Chapter 3 Preparing AXSM Cards and Lines for Communication
Selecting and Viewing Service Class Templates
Step 3 All ports on the card must be down before you can configure the card SCT. To verify the status of the
ports on the card, enter the dspports command.
M8850_LA.2.AXSM.a > dspports
ifNum Line Admin Oper. Guaranteed Maximum SCT Id ifType VPI minVPI maxVPI
State State Rate Rate (D:dflt (VNNI, (EVNNI,EVUNI)
used) VUNI)
----- ---- ----- ----- ---------- --------- ------ ------ ------ ------ ------
1 2.1 Up Down 1412830 1412830 5 NNI 0 0 0
2 2.2 Up Down 1412830 1412830 5 NNI 0 0 0
3 1.1 Up Up 1412830 1412830 5 NNI 0 0 0
Enter the dnport command to bring down any ports that are in the Admin State “Up”.
M8850_LA.2.AXSM.a > dnport 2
dnport/dnallports can disrupt traffic on existing connections.
Use this command only to modify partition parameters or change SCT
Do you want to proceed (Yes/No) ? y
Step 4 Enter the cnfcdsct command.
pop20two.1.AXSM.a > cnfcdsct <sctID>
Replace sctID with the number of the SCT that you want to assign to the card. Table 3-2 describes the
SCTID options.
Note When an AXSM card is powered up for the first time, the default card SCT file is used. You must
run this command in order to use another SCT file. The default SCT file s 0.
Step 5 To display the SCT assigned to a card, enter the following command:
pop20two.1.AXSM.a > dspcd
The display card report displays a row labeled “Card SCT Id,” which identifies the SCT assigned to the
card.
M8850_LA.1.AXSM.a > dspcd
Front Card Upper Card Lower Card
---------- ---------- ------------
Card Type: AXSM-4-622 SMFIR-2-622 SMFIR-2-622
State: Active Present Present
Serial Number: SAK0350007N SAK0346003F SBK043902FE
Boot FW Rev: 3.0(0.171)P2 --- ---
SW Rev: 3.0(0.171)P2 --- ---
800-level Rev: 09 13 A1
Orderable Part#: 800-5774-5 800-5383-1 800-5383-1
PCA Part#: 73-4504-2 73-4125-1 73-4125-1
CLEI Code: BAA1BADAAA 0000000000 BAI9ADTAAA
Table 3-2 sctID Options
SCT ID Description
1 Non-policing applications on PNNI-only networks.
2 Policing applications for PNNI-only networks.
3 Non-policing for combined MPLS/PNNI networks.
4 Non-policing applications for combined MPLS/PNNI networks.