Specifications

2-44
Cisco MGX 8850 (PXM45) and MGX 8950 Software Configuration Guide
Release 3, Part Number 78-14788-01 Rev. C0, January 2004
Chapter 2 Configuring General Switch Features
Verifying the Hardware Configuration
CLEI Code: BAA1BADAAA 0000000000 BAI9ADTAAA
Reset Reason: On Power up
Card Alarm: NONE
Failed Reason: None
Miscellaneous Information:
Type <CR> to continue, Q<CR> to stop:
M8850_LA System Rev: 02.01 Sep. 27, 2001 20:24:09 PST
MGX8850 Node Alarm: NONE
Crossbar Slot Status: Present
Alarm Causes
------------
NO ALARMS
b. In the worksheet in Table 2-10, write down the following information for each card:
• Upper back card type, which appears in the Upper Card column of the Inserted Card row.
• Lower back card type, which appears in the Lower Card column of the Inserted Card row.
• Primary software version, which appears in the Prim SW Rev row.
• Boot firmware version, which appears in the Boot FW Rev row.
Tip Another way to display a detailed report on a card is to enter the cc command to select the
card, then enter the dspcd command without a slot number. However, the preferred method
is to use the dspcd command with a slot number because this method can display
information on a card when card errors prevent access through the cc command.
Step 5 After you have entered the required information for all cards in Tabl e 2- 10 , use Table 2-11 to verify that
each card is installed in a slot that supports that card type. You also need to verify that the correct back
cards are installed for the corresponding front cards.
If any of the cards are installed incorrectly, refer to either the Cisco MGX 8850
Hardware Installation Guide (PXM45/B and PXM1E) or the Cisco MGX 8950 Hardware Installation
Guide for instructions on installing the cards correctly.