Specifications

2-42
Cisco MGX 8850 (PXM45) and MGX 8950 Software Configuration Guide
Release 3, Part Number 78-14788-01 Rev. C0, January 2004
Chapter 2 Configuring General Switch Features
Verifying the Hardware Configuration
Note If an RPM card is installed in the switch and does not appear in the dspcds command display, the RPM
card has not loaded the boot or runtime IOS software. In this case, you need to visually locate the RPM
cards by looking for them in the switch.
Step 3 In the worksheet in Table 2-10, write down the following information for each card:
• Front card type (from the “Card Type” column)
• Redundant slot
• Redundancy type
Step 4 For each slot in which a card is installed, complete the following tasks:
a. Enter the dspcd command as follows:
mgx8850a.7.PXM.a > dspcd slot
Table 2-10 Hardware Configuration Worksheet
Card Front Card Type Upper Back Card Lower Back Card
Primary
Software
Version
Boot
Firmware
Version
Redundant
Slot
Redundancy
Type
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16