Specifications

Contents
v
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
Configuring Clock Sources 2-30
Manually Configuring BITS Clock Sources 2-32
Enabling NCDP on a Node 2-34
Setting the LAN IP Addresses 2-36
Setting the Boot IP Address 2-36
Setting the Disk IP Address 2-39
Starting a CLI Session Through the LAN Port 2-41
Configuring for Network Management 2-42
Configuring the SNMP Trap Source IP Address 2-43
Configuring the SNMP Manager Destination IP Address 2-43
Configuring the Community String and General Switch Information 2-44
Verifying the Hardware Configuration 2-45
CHAPTER 3 Provisioning PXM1E Communication Links 3-1
Quickstart Provisioning Procedures 3-2
Line Configuration Quickstart 3-2
ATM Trunk Configuration Quickstart 3-3
PNNI UNI Port Configuration Quickstart 3-5
SVC Configuration Quickstart 3-7
SPVC and SPVP Configuration Quickstart 3-8
PNNI Virtual Trunk Configuration Quickstart 3-9
BPX PNNI Trunk Configuration Quickstart 3-12
AINI Link Configuration Quickstart 3-14
IISP Link Configuration Quickstart 3-15
XLMI Link Configuration Quickstart 3-17
Cisco IGX Feeder to MGX 8830 or MGX 8850 (PXM1E) Configuration Quickstart 3-19
General PXM1E Configuration Procedures 3-21
Configuring the Card Mode 3-21
Setting Up Lines 3-22
Bringing Up Lines 3-22
Configuring Lines 3-23
Verifying Line Configuration 3-28
Configuring Inverse Multiplexing for ATM 3-28
Creating an IMA Group 3-29
Configuring an IMA Group 3-31
Adding an IMA Link to an IMA Group 3-35
Configuring IMA Links 3-36
Adding an IMA Port 3-37
Establishing Redundancy Between Two Lines with APS 3-40