Specifications

9-49
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
Chapter 9 Switch Operating Procedures
Managing PXM1E Partitions
minVpi Minimum VPI number for this port. For UNI ports, enter a value in the range from
0 to 255. For NNI ports, enter a value in the range from 0 to 4095.
Note This parameter applies only to PXM1E and AXSM cards.
maxVpi Maximum VPI number for this port. For UNI ports, enter a value in the range from
0 to 255. For NNI ports, enter a value in the range from 0 to 4095. The value for
<maxVpi> cannot be less than for <minVpi>.
Note This parameter applies only to PXM1E and AXSM cards.
minVci Minimum VCI number for this port. Enter a number in the range from 32 to 65535.
To support features planned for the future, Cisco recommends setting the minimum
VCI to 35 or higher.
Note This parameter applies only to PXM1E and AXSM cards.
maxVci Maximum VCI number for this port. Enter a number in the range from 32 to 65535.
Note This parameter applies only to PXM1E and AXSM cards.
minConns Specifies the guaranteed number of connections.
On the PXM1E UNI/NNI, the ranges vary according to the line types, as follows:
• For OC3, T3, and E3 lines, the range is 10-27000.
• For T1 and E1 lines, the range is 10-13500.
On the AXSM series of cards, the range is 10 through the maximum number of
connections in the port group.
Note This parameter applies only to PXM1E and AXSM cards.
maxConns Maximum number of simultaneous connections allowed on this port. The range is
the same as described for the <minConns> parameter. This parameter must be set
to number that is greater than the number defined for <minConns>.
Note This parameter applies only to PXM1E and AXSM cards.
available
connections
Logical channel number. Range: 0–16000.
Note This parameter applies only to FRSM12 cards.
minDlci Lowest data-link connection identifier (DLCI). A value that specifies the DLCI in
a Frame Relay network:
• Two-byte header—Range: 1–1023
• Four-byte header—Range: 0–8388607
The value specified must be n * 32768, where n is a number from 0 to 255.
Note This parameter applies only to FRSM12 cards.
maxDlci Highest data-link connection identifier (DLCI). A value that specifies a DLCI in a
Frame Relay network:
• 2-byte header—Value range: 1 –1023
• 4-byte header—Value range: 0 –8388607
The value specified must be (n * 32768)-1, where n is a number from 1 to 256.
Note This parameter applies only to FRSM12 cards.
Table 9-23 Parameters for the cnfpart Command (continued)
Parameter Description