Specifications

9-11
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
Chapter 9 Switch Operating Procedures
Determining the Software Version Number from Filenames
Deleting ILMI Prefixes
The following procedure describes how to delete an ILMI address prefix from a port.
Note The procedure for adding ILMI prefixes is described in “Configuring ILMI Dynamic Addressing” in
Chapter 3, “Provisioning PXM1E Communication Links.”
Step 1 Establish a configuration session using a user name with GROUP1 privileges or higher.
Step 2 To view the ILMI prefixes assigned to a port, enter the dspprfx command as follows:
mgx8830a.1.PXM.a > dspprfx <portid>
Replace <portid> with the port address using the format slot:bay.line:ifnum. These parameters are
described in Table 9-1. For example:
mgx8830a.1.PXM.a > dspprfx 10:2.2:4
INFO: No Prefix registered
In the example above, no ILMI prefixes have been assigned to the port, so the port will use the prefix
configured for the SPVC prefix.
Step 3 To prepare for deleting an ILMI prefix, down the port to be configured with the dnpnport command.
For example:
mgx8830a.1.PXM.a > dnpnport 10:2.2:4
Step 4 Enter the following command to delete an ATM prefix for a port:
mgx8830a.1.PXM.a > delprfx <portid> <atm-prefix>
Replace portid using the format slot:bay.line:ifNum. Table 9-1 describes these parameters.
Replace atm-prefix with the 13-byte ATM address prefix in use.
Step 5 Up the port you configured with the uppnport command. For example:
mgx8830a.1.PXM.a > uppnport 10:2.2:4
Step 6 To verify the proper ATM prefix configuration for a port, re-enter the dspprfx command.
Determining the Software Version Number from Filenames
The following version management commands require a version number to be entered in a specific
format:
• abortrev
• burnboot
• commitrev
• loadrev
• runrev
• setrev