Specifications

3-51
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
Chapter 3 Provisioning PXM1E Communication Links
General PXM1E Configuration Procedures
Step 4 To display a list showing the resource partition you have created, enter the following command:
mgx8830a.1.PXM.a > dspparts
Step 5 To display the configuration of a specific resource partition, note the interface and partition numbers and
enter the following command:
mgx8830a.1.PXM.a > dsppart <ifNum> <partId>
Table 3-10 describes the parameters for this command.
The following example shows the report provided by the dsppart command.
mgx8830a.1.PXM.a > dsppart 1 1
Interface Number : 1
Partition Id : 1 Number of SPVC: 0
Controller Id : 2 Number of SPVP: 0
egr Guaranteed bw(.0001percent): 1000000 Number of SVC : 0
egr Maximum bw(.0001percent) : 1000000
ing Guaranteed bw(.0001percent): 1000000
egr Maximum bw(.0001percent) : 1000000
min vpi : 0
max vpi : 4095
min vci : 1
max vci : 65535
guaranteed connections : 10000
maximum connections : 10000
Note Partition ID 1 is reserved for PNNI.
Note For more information on working with partitions, see the “Managing PXM1E Partitions” section in
Chapter 9, “Switch Operating Procedures.”
minConns Specifies the guaranteed number of connections. On the PXM1E UNI/NNI, the ranges
vary according to the line types, as follows:
• For OC3, T3, and E3 lines, the range is 10-27000.
• For T1 and E1 lines, the range is 10-13500.
maxConns Specifies the guaranteed number of connections. On the PXM1E UNI/NNI, the ranges
vary according to the line types, as follows:
• For OC3, T3, and E3 lines, the range is 10-27000.
• For T1 and E1 lines, the range is 10-13500.
Table 3-10 Parameters for the addpart Command (continued)
Parameter Description