Specifications

3-47
Cisco MGX 8850 (PXM1E/PXM45), Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Configuration Guide
Release 5.0.10, OL-3845-01 Rev. B0, August 16, 2004
Chapter 3 Provisioning PXM1E Communication Links
General PXM1E Configuration Procedures
Step 5 To display a list of the ports configured on the PXM1E card, enter the following command:
mgx8830a.1.PXM.a > dspports
This command displays all configured ports on the PXM1E card. Port numbers are listed in the ifNum
(interface number) column. If you want to view information on a particular port, note the number of that
port.
Step 6 To display the port configuration, enter the following command:
mgx8830a.1.PXM.a > dspport <ifNum>
Replace <ifNum> with the number assigned to the port during configuration. The following example
shows the report for this command:
mgx8830a.1.PXM.a > dspport 1
Interface Number : 1
Line Number : 2.3 IMA Grp Number : N/A
Admin State : Up Operational State : Up
Guaranteed bandwidth(cells/sec): 353207 Number of partitions : 1
Maximum bandwidth(cells/sec) : 353207 Number of SPVC : 0
ifType : NNI Number of SPVP : 0
VPI number (VNNI, VUNI) : 0 Number of SVC : 3
MIN VPI (EVNNI, EVUNI) : 0 MAX VPI (EVNNI, EVUNI): 0
SCT Id (Conf./InUse) : 0/0=Def
F4 to F5 Conversion : Disabled
Tip To change the port configuration, enter the cnfport command, or enter the delport command to delete
a port configuration. You can also activate and deactivate ports entering the upport and dnport
commands. For more information on these commands, refer to the Cisco MGX 8850 (PXM45/PXM1E),
Cisco MGX 8950, Cisco MGX 8830, and Cisco MGX 8880 Command Reference, Release 5.
Modifying ATM Ports
After you add a port, you can modify the following parameters with the cnfport command:
• Minimum cell rate
• Maximum cell rate
• Port SCT ID
• Minimum VPI for EVUNI and EVNNI
• Maximum VPI for EVUNI and EVNNI
To modify an ATM port, use the following procedure.
Step 1 Establish a configuration session using a user name with GROUP1 privileges or higher.
Step 2 Get the port number that you want to modify. To display a list of the ports configured on the PXM1E
card, enter the following command:
mgx8830a.1.PXM.a > dspports