User guide

7-9
Cisco Media Gateway Manager for the Cisco MGX 8260 Media Gateway User Guide
Release 1.0, Part Number 78-11705-01, December 2000
Chapter 7 Cisco MGX 8260 Node Management
Configuring IPDC
The following table summarizes the Cisco WebViewer support for D Channels:
Configuring IPDC
IPDC is an alternative to the MGCP protocol for controlling voice calls through the Cisco MGX 8260
Media Gateway. When using IPDC, you do not have to configure sessions or backhaul channels.
Note Cisco MGM does not support IPDC.
To configure IPDC, configure the following parameters:
• MGCP or IPDC mode
• IP addresses and ports—The IP addresses and health check status for IPDC
• Core settings—The protocol operational timers and settings
• COT tones—The continuity test receive and transmit tones
• IPDC timers—The IPDC link timer settings
The following table summarizes the Cisco WebViewer support for IPDC:
Table 7-9 D Channel Configuration Map
Task Navigation Tree Selection Screen Screen Link
MACSAP profile configuration Protocol>ISDN>Macsap Profile Macsap Profile + to add
- to delete
D Channel configuration Protocol>DChan Config D Chan Config + to add
- to delete
i for details
c for MACSAP
counters
A for DLSAP
counters
Viewing LAPD parameters Protocol>ISDN>Lapd LAPD Card Table none
Table 7-10 IPDC Configuration Map
Task Navigation Tree Selection Screen Screen Link
Switch from MGCP to IPDC Node>System System Configuration Set
View IPDC status Protocol>IPDC>Configuration IPDC Configuration
IP address configuration Protocol>IPDC>Configuration IPDC Configuration, Soft
Switch Configuration pane
Set
Pseudo IP address configuration for
Fast Ethernet ports
Protocol>IPDC>Configuration IPDC Configuration, Status
and Core Setting pane
Set
IPDC core protocol settings Protocol>IPDC>Configuration IPDC Configuration, Status
and Core Setting pane
Set
COT configuration Protocol>IPDC>Configuration IPDC Configuration, COT
Configuration pane
Set