User guide
7-4
Cisco Media Gateway Manager for the Cisco MGX 8260 Media Gateway User Guide
Release 1.0, Part Number 78-11705-01, December 2000
Chapter 7 Cisco MGX 8260 Node Management
Configuring Voice Ports
Configuring Voice Ports
This section describes the procedure for viewing, adding, or changing voice ports. Voice ports identify
the physical location and characteristics of a voice interface at a DS0 level. A Media Gateway Controller
manages SVC (Switched Virtual Circuit) end points and connections.
The Cisco MGX 8260 Media Gateway identifies a voice port by a logical port number that is independent
of the port’s physical location. The following parameters describe the physical location:
• Slot number
• Port number
• DS0 number
NSC lines always need a voice port configured; BSC lines have a default configuration. When you add
or change a voice port, you associate a logical port number with these physical descriptors. Voice ports
have settings for dejitter, packet loading, and other voice parameters.
Viewing Active Calls
Active call information is useful for audits or trouble analysis. The Cisco MGX 8260 Media Gateway
displays active calls as follows
• Viewing calls by physical resource
• Viewing calls by transaction
DMC line mapping Line>DMC T3-T1 Mapping DMC T3-T1 Mapping + to map
i to change
- to delete
Fast Ethernet line configuration Line>Ether>All-Lines Ether Line Configuration + to add
i to change
- to delete
Fast Ethernet admin status change Line>Ether>All-Lines Ether Line Configuration Link Up or
Link Down
OC-3 line configuration Line>SONET>All-Lines Sonet Line Configuration + to add
i to change
- to delete
SONET E-RDI and trace configuration Line>SONET>All-Lines Sonet Line Configuration i to change
Table 7-4 Line Configuration Map (continued)
Task Navigation Tree Selection Screen Screen Link
Table 7-5 Voice Port Configuration Map
Task Navigation Tree Selection Screen Screen Link
View all ports Port>All-Ports Common Port i for details
View voice ports Port>Voice>All-Ports Voice Port Configuration + to add
i to change
- to delete