User guide

7-3
Cisco Media Gateway Manager for the Cisco MGX 8260 Media Gateway User Guide
Release 1.0, Part Number 78-11705-01, December 2000
Chapter 7 Cisco MGX 8260 Node Management
Configuring Lines
Configuring Lines
Line and port management screens facilitate viewing, configuring, and deleting voice and data services.
The following list summarizes the line configuration parameters:
• DS0—Line number, port, and operational status
• DS1 or E1—Line number, port, parameters, and operational status
• DS3—Line number, port, parameters, and operational status
• DMC mapping—Source and destination DS1 and DS3 lines
• Fast Ethernet—IP address, gateway, protocol, and operational status
• Static Route—Destination, line, port, and priority
Note The DS1 and E1 modes are mutually exclusive.
The DMC maps source DS1 channels from the DS3 interface to destination DS1 channels on the NSCs.
The mapping is one-to-one and can connect any source DS1 to any destination DS1.
Note The NSC should be in the backplane more for correct DMC operation.
Table 7-3 Clock Source Configuration Map
Configuration Task Navigation Tree Selection Screen Screen Link
Primary and secondary clock source for
serial lines
Node>Clock Source Clock Source Set
Switching clock sources Route>Clock Source IP Route Switch Clock
Source
Table 7-4 Line Configuration Map
Task Navigation Tree Selection Screen Screen Link
View all lines Line>All-Lines>All-Lines Common Line i for details
DS0 channel configuration Line>Dsx0>All-Dsx0 Dsx0 Status - to delete
DS1 line configuration Line>Dsx1-T1>All-Lines Dsx1-T1 Line Configuration + to add
i to change
- to delete
E1 line configuration Line>E1>All-Lines E1 Line Configuration + to add
i to change
- to delete
DS3 line configuration Line>Dsx3>All-Lines Dsx3 Line Configuration + to add
i to change
- to delete