Troubleshooting guide

6-192
Cisco PGW 2200 Softswitch Release 9.8 Operations, Maintenance, and Troubleshooting Guide
OL-0800-14
Chapter 6 Troubleshooting the Cisco PGW 2200 Softswitch Platform
Platform Troubleshooting
Step 21 Repeat Step 15 through Step 19 for additional Cisco PGW 2200 Softswitch nodes.
The system displays text like the following:
mgcusr on <BAMS1> successfully configured
Do you want to configure second interface for <BAMS1>? n
Step 22 Enter n (no) and press Enter.
The system displays text like the following:
Please enter a PGW or BAMS host name, or q to quit
Enter a host name now:
Step 23 Continuing on the standby Cisco BAMS, type the active Cisco BAMS unit information (Cisco BAMS
name, Cisco BAMS login password).
Step 24 When all the Cisco BAMS interfaces have been configured, type q to quit and press Enter.
The system displays text like the following:
Done
Note Watch for the following error message. If some hosts are not configured, follow the
recommendation in this message.
Failed to configure some hosts. Please check for SSH installation on these hosts and/or the
username and password for these hosts.
Step 25 Log in to the active Cisco BAMS as root.
Step 26 Change the directory. Type the following command and press Enter:
# cd /opt/install
Step 27 Enter the following command and press Enter:
# setupSSH.sh
The system displays text like the following:
BAMS is installed, proceeding with SSH configuration
Warning:
Before running this script, SSH must be installed on all PGW and BAMS hosts
This script will disable the standard FTP client on BAMS and set up
SSH connections from BAMS to PGW and from BAMS to BAMS.
If you want to use the standard FTP client, it is still available
in the file /usr/bin/ftp.orig
Do you want to continue [y/n]: