Troubleshooting guide

6-113
Cisco PGW 2200 Softswitch Release 9.8 Operations, Maintenance, and Troubleshooting Guide
OL-0800-14
Chapter 6 Troubleshooting the Cisco PGW 2200 Softswitch Platform
Resolving SS7 Network Related Problems
Step 3 Modify the RLM timer properties, as needed, by issuing the
prov-ed:lnksetprop:name=“protocol_fam”,prop_name=“value”,prop_name=“value”,... command.
Where:
• protocol_fam—MML name of the associated protocol family.
• prop_name—Name of the RLM timer property you want to modify.
• value—Value you want to set for the specified RLM timer property.
For example, to change the values of RLM timers for an ANSI signaling environment, enter the
prov-ed:lnksetprop:name=“ss7-ANSI”,timerLinkDownMin=“120”,timerLinkEcho=“15”
command.
Step 4 Save and activate your provisioning session by using the procedure in the “Saving and Activating your
Provisioning Changes” section on page 3-65.
Step 5 Reboot your system as described in the “Rebooting Your System to Modify Properties” section on
page 6-117.
Verifying and Modifying ISUP Timer Settings
When resolving signaling problems, you might need to verify that the Cisco PGW 2200 Softswitch ISUP
timer settings the conform to the settings on the associated network elements. If the settings do not
match, modify the settings for the ISUP timers. You can modify the settings of the local ISUP timers.
The timers are grouped according to the associated ISUP protocols for each timer. You cannot change
other ISUP timers.
Table Table 6-2 lists the configurable ISUP timers.