Troubleshooting guide

3-85
Cisco PGW 2200 Softswitch Release 9.8 Operations, Maintenance, and Troubleshooting Guide
OL-0800-14
Chapter 3 Cisco PGW 2200 Softswitch Platform Operations
Regular Operations
Modifying an ACC Response Category on a System Configured for Signaling
To modify an ACCRC on a system that is configured for signaling, perform the following steps:
Note You can use the Cisco VSPT to modify an ACCRC. For more information on using the Cisco VSPT, see
Cisco Voice Services Provisioning Tool Users Guide.
Step 1 Start a provisioning session, as described in the “Starting a Provisioning Session” section on page 3-64.
Step 2 Enter the following command to modify the configuration of an ACCRC:
prov-ed:accrespcat:name=" cat_name "[, field_name = value , field_name = value... ]
Where:
• cat_name—MML name for the ACCRC.
• field_name—ACCRC field that specifies a percentage of calls that is released when an adjacent
signaling point sends a congestion indication of a particular ACL level. You can modify the
following fields:
– acl1drcant—Specifies the percentage of calls that is defined in value. Calls are released when
an adjacent signaling point sends an ACL indication of 1.
– acl2drcant—Specifies the percentage of calls that is defined in value. Calls are released when
an adjacent signaling point sends an ACL indication of 2.
– acl3drcant—Specifies the percentage of calls that is defined in value. Calls are released when
an adjacent signaling point sends an ACL indication of 3.
• value—Percentage of calls that is released. The valid range is 0 through 100.
For example, to modify the configuration of an ACCRC called cat1 so that 30 percent of calls are
rejected when an ACL of 1 is received, enter the following command:
prov-ed:accrespact:name=”cat1”,acl1drcant=30
Step 3 Save and activate your provisioning changes as described in the “Saving and Activating your
Provisioning Changes” section on page 3-65.
Modifying an ACC Response Category on a System Configured for Call Control
To modify an ACCRC on your system when it is configured for call control, perform the following steps:
Note You can also use the Cisco VSPT to modify an ACCRC. For more information on using the Cisco VSPT,
see Cisco Voice Services Provisioning Tool Users Guide.
Step 1 Start a provisioning session, as described in the “Starting a Provisioning Session” section on page 3-64.
Step 2 Enter the following command to modify the configuration for an ACCRC:
prov-ed:accrespcat:name=" cat_name "[, field_name = value , field_name = value... ]
Where:
• cat_name—MML name for the ACCRC.