Troubleshooting guide

3-64
Cisco PGW 2200 Softswitch Release 9.8 Operations, Maintenance, and Troubleshooting Guide
OL-0800-14
Chapter 3 Cisco PGW 2200 Softswitch Platform Operations
Regular Operations
When you enter this command with the optional command to provide detailed call data, the system
returns a response like the following:
MGC-01 - Media Gateway Controller 2002-05-13 10:02:08.833 PST
M RTRV
“sippath-sip-outbound:CALL=OUT,MATE_FAMILY=SIP,FROM=3330000,TO=sipp"
"sippath-sip-outbound:CID=5248672-32474@10.0.120.3,"
"sippath-sip-outbound:CALL=IN,MATE_FAMILY=SIP,FROM=sipp,TO=3330000"
"sippath-sip-outbound:CID=5248672-32474@10.0.120.3,"
"sippath-sip-outbound:CALL=OUT,MATE_FAMILY=SIP,FROM=3330000,TO=sipp"
"sippath-sip-outbound:CID=5248673-32474@10.0.120.3,"
"sippath-sip-outbound:CALL=IN,MATE_FAMILY=SIP,FROM=sipp,TO=3330000"
"sippath-sip-outbound:CID=5248673-32474@10.0.120.3,"
"sippath-sip-outbound:CALL=OUT,MATE_FAMILY=SIP,FROM=3330000,TO=sipp"
"sippath-sip-outbound:CID=5248674-32474@10.0.120.3,"
"sippath-sip-outbound:CALL=IN,MATE_FAMILY=SIP,FROM=sipp,TO=3330000"
"sippath-sip-outbound:CID=5248674-32474@10.0.120.3,"
"sippath-sip-outbound:CALL=OUT,MATE_FAMILY=SIP,FROM=3330000,TO=sipp"
"sippath-sip-outbound:CID=5248675-32474@10.0.120.3,"
Provisioning a Cisco PGW 2200 Softswitch
The following sections describe the operations that you can use to provision the Cisco PGW 2200
Softswitch:
• Starting a Provisioning Session, page 3-64
• Saving and Activating your Provisioning Changes, page 3-65
• Ending a Provisioning Session Without Activating your Changes, page 3-66
• Invoking Dynamic Reconfiguration, page 3-66
• Retrieving Provisioning Data, page 3-69
• Provisioning a Dial Plan, page 3-75
• Importing Provisioning Data, page 3-75
• Exporting Provisioning Data, page 3-76
• Managing Automatic Congestion Control, page 3-77
For more detailed information about provisioning the Cisco PGW 2200 Softswitch, see
Cisco PGW 2200 Softswitch Release 9.8 Provisioning Guide.
Starting a Provisioning Session
To start a provisioning session, log into the active Cisco PGW 2200 Softswitch, start an MML session,
and enter the prov-sta::srcver=“curr_ver”,dstver=“mod_ver” command:
Where:
• curr_ver—Name of the current configuration version. In place of the name of the current
configuration version, you can also enter:
– new—New default configuration session; no existing source configuration is available.
– active—Selects the active configuration as the source for configuration changes.