Specifications

4-26
Cisco MGX 8260 Command Line Interface Guide
Release 1.2, Part Number 78-10987-01 Rev. B0, January, 2002
Chapter 4 Service Management
Configuration Tasks for Ports
Configuring E-RDI and SONET Trace
To change E-RDI parameters, follow these steps:
Step 1 Change extended rdi parameters for SONET lines using the chsonetperdi command, specifying the
location and E-RDI parameters. See the “chsonetperdi” section on page 9-123.
Step 2 Change path trace parameters for SONET lines using the chsonettrace command, specifying the
location and path trace parameters. See the “chsonettrace” section on page 9-125.
Step 3 Change expected path trace parameters for SONET lines using the chsonetexptrace command,
specifying the location and path trace parameters. See the “chsonetexptrace” section on page 9-119.
Configuration Tasks for Ports
See the following sections for port configuration tasks.
• Configuring Voice Ports
• Viewing All Ports
Configuring Voice Ports
Voice ports use voice over IP or ATM. The MGX 8260 Media Gateway identifies a voice port by a
logical port number that is independent of the port’s physical location. The following parameters
describe the physical location:
• Slot number
• Port number
• DS0 number
When you add or change a voice port, you associate a logical port number with these physical
descriptors.
Adding Voice Ports
To add a voice port, enter the addvport command as described in the “addvport” section on page 9-38.
For example, to add logical voice port 4 using DS0 4 of DS1 line 1 in slot 13, type the following
command:
addvport 13 4 1 4 1