Specifications

4-21
Cisco MGX 8260 Command Line Interface Guide
Release 1.2, Part Number 78-10987-01 Rev. B0, January, 2002
Chapter 4 Service Management
Configuration Tasks for Lines
To view the information for all OC-3 lines, enter the lssonetlns command. The system lists summary
information for all OC-3 lines:
=======================================================================
Sonet Lines (lssonetlns)
=======================================================================
Slot.Line Interface Type Frame Type Admin Status Line Status(2)
========= ============ =========== =========== ==========
9.1 oc3 sts1 up 10
9.2 oc3 sts3c up 10
For a description of the information, see the previous table.
Line Status(2) The LED status, expressed as a bitmap:
Bit 0: Solid green
Bit 1: Blinking green
Bit 2: Solid yellow
Bit 3: Blinking yellow
Bit 4: Red
Interface Type The type of interface, either OC3 or STM-1
Frame Type The type of framing, either STS-3c or STS-1
Loopback State The loopback state:
• No loop
• Line loop
• Serial loop
• Parallel loop
HCS Masking The HCS masking state (reserved for future use)
Payload Scrambling The payload scrambling state, either enabled or
disabled
Frame Scrambling The frame scrambling state, either enabled or
disabled
Transmit Clock Source The clock source for the transmit signal, either
loop or local timing
Support Path E-RDI The support path for enhanced remote defect
indicator, either enabled or disabled
Displayed Information Description