Specifications

4-15
Cisco MGX 8260 Command Line Interface Guide
Release 1.2, Part Number 78-10987-01 Rev. B0, January, 2002
Chapter 4 Service Management
Configuration Tasks for Lines
To view the information for all Fast Ethernet lines, enter the lsethlns command. The system lists
summary information for all Fast Ethernet lines:
=======================================================================
Ether Lines (lsethlns)
=======================================================================
Line IP Address Subnet Mask Status Gateway Addr
====== =============== =============== ================ ===============
9.1 10.15.26.97 255.255.255.0 active 10.15.26.1
9.2 10.15.26.98 255.255.255.0 active 10.15.26.1
9.3 10.15.26.99 255.255.255.0 active 10.15.26.1
Adding a Fast Ethernet Line
To add a Fast Ethernet line, follow these steps:
Step 1 Enter the addethln command as described in the “addethln” section on page 9-18.
Operational Status The operational status for the line:
• active
• inactive
• failed
• link down in active state
• link down in inactive state
Duplex Mode The duplex mode for this line
• full
• half
Displayed Information Description
Displayed Information Description
Line The slot and line number for the Fast Ethernet line
IP Address The IP address for the Fast Ethernet line
Subnet Mask The IP address mask for the Fast Ethernet line
Status The operational status for the line:
• active
• inactive
• failed
• link down in active state
• link down in inactive state
Gateway Addr The primary IP gateway for this line