Specifications

4-14
Cisco MGX 8260 Command Line Interface Guide
Release 1.2, Part Number 78-10987-01 Rev. B0, January, 2002
Chapter 4 Service Management
Configuration Tasks for Lines
To view all DS3 to DS1 mappings, enter the lsm13s command. The system lists all map table entries:
==================================================================
DMC T3-T1 Mapping Entries (lsm13s)
==================================================================
Src T3 Line Src T1 Line Dst Slot Dst T1 Line
============= ============= ============= ================
1 3 1 1
1 4 1 4
1 5 1 3
Configuring Fast Ethernet Lines
The SCC has four Fast Ethernet lines. This section explains how to configure and manage these lines.
Viewing Fast Ethernet Configuration and Status
To view information for a single Fast Ethernet line, enter the lsethln command, specifying the slot and
line number of the SCC (slot.line).
The system displays detail information for the Fast Ethernet:
=======================================================================
Ether Line Entry (lsethln)
=======================================================================
Ether Line : 9.1
MAC Address : 00.00.00.00.00.20
IP Address : 10.15.26.98
Subnet Mask : 255.255.255.0
Primary Gateway : 10.15.26.1
Router Discovery Protocol: enabled
Target State : active
Operational Status : active
Duplex Mode : full
Displayed Information Description
Ether Line The slot number and line number of the Fast
Ethernet
MAC Addr The physical address of the line
IP Addr The IP address for this host
Subnet Mask The IP subnet mask for this host
Primary Gateway The primary gateway for this line
RDP The Router Discovery Protocol status
• disabled
• enabled
Target State The desired line state:
• active
• inactive