Specifications

4-11
Cisco MGX 8260 Command Line Interface Guide
Release 1.2, Part Number 78-10987-01 Rev. B0, January, 2002
Chapter 4 Service Management
Configuration Tasks for Lines
For example, to activate a line loopback on DS3 line 501 in logical slot 11:
chds3ln 11.501 # # # # 3
Deleting DS3 Lines
To delete a DS3 line, enter the delds3ln command, specifying the logical number slot and line number
(slot.line), and the number of lines to delete. Valid slot values: 7 or 8 for the DMC card; 11 -16 for the
BSC card. Valid line values are 1-6.
The system deactivates the DS3 line and removes its configuration from the database.
The following example deletes two DS3 lines beginning at line 501 in slot 11:
delds3ln 11.501 2
Mapping DMC Lines
The DMC maps source DS1 channels from the DS3 interface to destination DS1 channels on the NSC.
The mapping is one-to-one and can connect any source DS1 to any destination DS1 (see Figure 4-1).
Figure 4-1 Example of DS3 to DS1 Mapping from DMC to NSC
3
1938
1
DMC
NSC 1 Destinatio
n
NMC slot
Destinatio
n
DS1 line
S
ource DS3 line
S
ource DS1 line
2
3
4
5
6
1
2
3
4
16
1
2
3
4
5
28
NSC 5
1
2
3
4
16