Specifications

4-10
Cisco MGX 8260 Command Line Interface Guide
Release 1.2, Part Number 78-10987-01 Rev. B0, January, 2002
Chapter 4 Service Management
Configuration Tasks for Lines
Viewing Summary DS3 Information
To view summary information for all DS3 lines, enter the lsds3lns command.
The system displays summary information for all DS3 lines:
=======================================================================
DS3 Lines (lsds3lns)
=======================================================================
Slot.Line Line Type Line Coding LED Status
========= ========== ============ =============
16.501 dsx3M23 dsx3B3ZS Solid RED
16.502 dsx3M23 dsx3B3ZS Solid RED
16.503 dsx3M23 dsx3B3ZS Solid RED
16.504 dsx3M23 dsx3B3ZS Solid RED
Adding DS3 Lines
When adding DS3 lines that contain DS1 channels, add the DS3 lines first.
To add DS3 lines, follow these steps:
Step 1 Enter the addds3ln command (see “addds3ln” section on page 9-14).
The following example adds two new DS3 lines with default settings to slot 11 lines 501 and 502:
addds3ln 11.501 2
Note The system stops adding lines on the first failure.
Step 2 Add other DS3 lines, as necessary.
Step 3 Check the configuration, using the lsds3ln command, specifying the location (slot.line) of the new line.
Changing DS3 Lines
Warning Changing a DS3 line interrupts service. Perform this operation during light traffic
periods or in a pre-arranged maintenance window.
To change the settings of a DS3 line, enter the chds3ln command as described in the “chds3ln” section
on page 9-59.
Displayed Information Description
Slot.Line The slot and line number of the specified DS3 line.
Line Type The DS3 C-bit usage.
Line Coding The zero code suppression for this interface.
LED Status The LED indication on the card.