Specifications

4-9
Cisco MGX 8260 Command Line Interface Guide
Release 1.2, Part Number 78-10987-01 Rev. B0, January, 2002
Chapter 4 Service Management
Configuration Tasks for Lines
Displayed Information Description
DS3 Line The slot and line number of the specified DS3 line
Line Type The DS3 C-bit usage:
• dsx3M23
• dsx3SYNTRAN (reserved for future use)
• dsx3CbitParity (reserved for future use)
Line Coding The line coding format, fixed at dsx3B3ZS.
Send Code The type of code sent across the DS3 interface
• dsx3SendNoCode
• dsx3SendLineCode
• dsx3SendPayloadCode
• dsx3SendResetCode
• dsx3SendDS1LoopCode
• dsx3SendTestPattern
Line Status The line status, expressed as a bitmap. The alarm list this display shows this
information in text form.
Time Elapsed The number of elapsed seconds since the start of the near end error
measurement period
Valid Intervals The number of 15 minute intervals during which the system collected valid
data for the near end
Cable Length The approximate length of the DS3 cable:
• upto225Ft—0 to 225 feet
• bt225To300—225 to 300 feet
• bt300To450—300 to 450 feet
• bt450To900—450 to 900 feet
Transmit Clock Source The source for the transmit signal clock
• loopTiming
• localTiming
• throughTiming
Circuit Identifier The Cisco equipment circuit identifier, expressed as a text string
Alarm Alarm state, either major, minor, or off
<alarm list> The current state of specific alarms, either yes or no. For more information,
see the Alarms chapter.
Rcv Test Code Receiving a test code, yes or no
Other Failure Other failure, yes or no